Configuration guide

Offline Raid Alert

Post a Discord alert when a clan's base sensors trip. Set the alert channel and ping mode, and manage every linked base. This page covers every setting.

Time
5 minutes
You need
Manage Server (website) or Owner, Co-Owner, Head Admin (Discord)
Applies to
Per Rust server

Overview

Clan leaders wire a sensor circuit at their base and link it with /raid link. When it trips, the bot posts a 🧨 RAID ALERT in the channel you choose and pings according to your ping mode.

Before you start
  • Clans must exist first (Clans).
  • The alert channel must be one the bot can post in.
  • Players link their own bases in Discord. Links cannot be created from the website, because the bot reads the player's live position to set a 50 metre anti-grief radius.

Setup & Configuration

On the website
  • Log in to the RustyWorks website, open Servers Configure, pick your server and select Offline Raid Alert. Pick your server.
  • Alert Settings at the top, and Active Base Alerts below, which lists every linked clan.
In Discord
  • Run /raid config and pick the server, enable it, set the alert channel, the ping mode and the role if needed.

Alert settings

Setting What it does
Raid Alert System Master switch. When off, no alerts are sent and players cannot link new bases
Alert Channel Where alerts are posted. Required before you can enable
Ping Mode None, Ping Clan Users (mentions every member of the raided clan) or Ping a Role
Role to Ping The role mentioned on every alert. Required for the role mode

Press Save Raid Settings.

Active base alerts

The table lists each clan with its RF Frequency, Triggers and Last Trigger. Remove disconnects a base, which is the same as /raid unlink. The clan can link again afterwards.

What players do

Players link a base in Discord and build the circuit. Tell them these steps:

  1. A clan Leader or Co-Leader stands in the base and runs /raid link.
  2. Build Seismic Sensor, Timer, Splitter and RF Broadcaster in the base. Set the Broadcaster to the frequency the bot gives.
  3. Confirm in Discord.

Commands & Usage

Command What it does Who can use it
/raid config Opens the admin settings Owner, Co-Owner, Head Admin
/raid link Links a base Clan Leader or Co-Leader
/raid unlink Removes a base alert. Staff can pick any clan Clan Leader or Co-Leader, staff

Troubleshooting

Problem Cause Fix
"Pick an alert channel before enabling" No channel is chosen Choose one
"Pick a role for Role ping mode" Role mode has no role Choose a role
Players cannot link a base The system is off Turn on Raid Alert System
No alert on a raid The circuit is not tripping Check the frequency matches the one the bot gave

Checked against RustyWorks on 29 Oct 2026.

Stuck on this step?

Tell us which setting you are on and what the bot said, and paste a screenshot if you can. Staff in the support Discord can usually fix it in a minute.